Cold Air Intake - High-flow, Aluminum Tube - NISSAN ALTIMA, L4-2.5L, 02-06; SILVE

479,99 USD
Disponibile
SKU
69-7060TS
The K&N 69-7060TS Typhoon cold-air intake system is a free-flowing, mandrel-bent aluminum tube air induction system designed to fit some Nissan Altima models. The restrictive factory air filter and air intake housing are replaced by the K&N Typhoon cold-air intake which is designed to pull in relatively cooler air and dramatically reduce air flow restriction by smoothing and straightening air flow. This allows your engine to inhale a larger amount of denser air than the factory air intake. More air means more usable power and acceleration throughout the engine's RPM range. The cold-air intake system accommodates the factory mass air sensor and transmission vent hose. The oversized cone shaped air filter comes with a water repellent DryCharger filter wrap to protect the filter from moisture. The air filter can be used for up to 100,000 miles before servicing is needed depending on driving conditions. This cold air intake is relatively easy to install usually in 90 minutes or less using existing factory mounting points. The tools needed are a screwdriver, a ratchet set and two Allen wrenches. Some Typhoon air intakes are not legal for sale or use in California and other states adopting California emission standards while others are CARB exempt and 50 state legal. Check the K&N catalog or website for vehicle applications and specific CARB status for each vehicle and air intake.
  • Guaranteed to increase horsepower
  • Designed to improve throttle response and engine sound
  • Free-flowing aluminum tubes
  • Easy to install, usually in 90 minutes or less
  • Filter lasts up to 100,000 miles before service is required
  • Replaces entire factory air intake system
  • Washable and reusable lifetime air filter
  • K&N Million Mile Limited Warranty
Estimated Horsepower Gain7.04 HP @ 5498 RPM
Replacement FilterRU-4870
Air Filter ColorRed
Air Filter MaterialCotton Gauze
Air Filter Outlet ShapeRound
Clamps Included9
Clamp MaterialStainless Steel
Clamp StyleRegular
Couplers Included3
System TypeComplete Cold-Air Intake System
Estimated Torque Gain6.7 lbft
Product Style69 Series Typhoon Kits
Intake Pipe Color / FinishSilver
Intake Pipe MaterialAluminum
CARB EO NumberD-269-32
Street Legal In All US StatesYes
TUV Approved (Europe)No
Weight7.8 lb (3.5 kg)
Product Box Height8.5 in (216 mm)
Product Box Length18.25 in (464 mm)
Product Box Width14.5 in (368 mm)
Mounting Hardware IncludedYes
WarrantyNo-Hassle Lifetime Limited
No cross references found for this part
+7.04

cavallo vapore

+6.7

coppia

Recommended Products

Search By Vehicle
*
Search By Dimension
L'articolo che hai aggiunto al carrello NON SI ADATTA al tuo veicolo
Questo articolo si adatta al tuo veicolo

L'articolo qui sotto si adatta al tuo veicolo